大家在查： FRS—DQ 立体声节目 represention 神圣化正直接坚信有人也是促使 ·阿齐布尔德 bind_token RobustOptimization

80mm

网络80毫米

80mm

80mm

80mm

80毫米

... 切割高度:80毫米 Cutting Height:80mm 工作频率:56次/分钟 Operation Frequency:56 times per minute ...

1

U, I or H sections , not further worked than hot - rolled, hot-drawn or extruded, of a height of less than 80mm.

槽钢、工字钢及 H 型钢，除热轧、热拉拔或热挤压外未经进一步加工，截面高度低于 80 毫米。

3

Only applicable to cutting carbon steel , it is especially suitable for cutting more than 80 mm thick metal sheet .

仅适用于切割碳钢，尤其适用于切割厚达 80mm 以上的金属板。

4

While its overhang dimensions are shortened by 45mm, its wheelbase is expanded by 80mm, allowing for additional rear legroom .

虽然它的悬尺寸缩短 45 毫米，它的轴距增加了 80 毫米，使更多的后部腿部空间。

5

The low section height design offers compact dimensions of 80mm (W) x 48mm (H), depending on the design and construction .

低高度设计节提供的尺寸 80 毫米（宽）x 四八毫米（主），根据设计和施工。

6

Plasma system applicable range of cut thickness from standard to 80 mm.

等离子系统适用的切割厚度范围为从标准到 80mm 。

7

The armor sometimes can go up to . 50 caliber BMG (Browning Machine Gun ) UL 752 lLevel 10 (80mm thick glass ).

这辆车的装甲间或可以达到抵御 .50 口径 BMG （勃朗宁机枪）子弹的 UL752Level10 防弹标准（相当于 80mm 厚的玻璃）。

8

In wiring, fold the wire for about 80mm as displayed in photo 1 in the location for installing the extension set .

在电线，电线倍约 80 毫米中显示的照片 1 的位置安装了可拓集合。

9

For large switching distances there are configurations with diameters of 80mm to 160mm.

对于大型开关距离与有直径 80 毫米至 160 毫米的配置。

10

Finally , a thin-wall cylinder with 2. 5mm thickness and 80mm high was manufactured by turning.

最后，实验采用车削方法在颗粒层中加工出高度 80mm 、壁厚 2.5mm 的薄壁筒状零件。

热词推荐

大家在看