大家在查： coming 木模 atherosclerosis 掩盖 Rowland vagrant agile 芭比 ship goods record

套管

na.casing; bushing; sleeve; casing pipe
网络cannula; thimble; Tube

套管

英-汉英-英网络释义

套管

na.

1.drivepipe; annular tubes; branch pipe; casing pipe; sleeve; sleeving; canula; cannula; casing; cothead; spigot; nozzle; connection; bushing; casing (drill hole)

2

These lights mount by means of a rubber bushing snapped into a 9 mm diameter panel cutout. There is no need for nuts or washers.

这些灯通过橡胶套管安装在直径 9 毫米的面板开孔上，不需要螺栓或垫圈辅助安装。

3

Make sure the top end of the strap is far enough down to leave room for the elastic casing .

确保包带的最高端是远远不够了离开套管的弹性空间。

4

The quartz sleeve of the UV lamp should be cleansed at least monthly by trained personnel of the operator or the system supplier .

应由系统供应商或曾受训练的人员至少每月清洁紫外光灯的石英套管一次。

5

The casing swabbing is often used in low pressure, low permeability and low production rate oilfields for the most economical production .

三低油田常采用套管抽汲方法达到最经济的采油目的。

6

Casing string is composed of some casing from screw joint casing and centering device . The length of any one of casing is about 10 meters.

套管柱是由若干个 10m 左右的套管经螺纹连接而成，并配有扶正器等配件，是井下管柱的一种。

7

8

Foam cementing is commonly used for cementing in a shale gas well , while perforation after casing set is often for well completion.

页岩气固井主要采用泡沫水泥固井技术，完井方式以套管固井后射孔完井为主。

9

The process sensor should be directly immersed into the material to be heated , or snugly inserted into a thermowell inside the fluid itself .

过程传感器应直接侵入到被加热的材料中，或紧贴在流体本身的热电偶套管上。

10

A mill is usually used to remove junk in the hole or to grind away all or part of a casing string.

铣鞋通常用于除去井下的碎屑或者研磨掉整个或部分套管。

11

In case of the specified parameters of the casing pipe , the ratio of the casing response to that of the formation is almost a constant .

在套管参数一定时，套管响应与地层的响应的比值近似一个常数。

12

A device used on the outside of the casing of a well to seal off formations or to protect certain zones.

为封堵地层或保护某些层段在井内套管外面所用的装置。

13

A component installed near the bottom of the casing string on which the cement plugs land during the primary cementing operation .

安装在套管柱底部附近的一个部件，在初次注水泥作业期间水泥塞坐放于其上。

15

A tapered , often bullet-nosed device fitted with a check valve and typically found at the bottom of a casing string.

一种装配有节流阀的锥型的，通常是圆头引导型的装置，典型地位于套管柱的最下端。

16

A tapered , often bullet -nosed piece of equipment often found on the bottom of a casing string.

一种锥型，通常是圆头引导器形状的器件，一般出现在套管柱的最下端。

17

The utility model discloses a connecting sleeve for a bit , and relates to a connecting device for the bit .

一种钻头连接套管，涉及到一种钻头连接装置。

18

Prior to setting surface casing , the cellar also takes mud returns from the well , which are pumped back to the surface mud equipment .

在下入表层套管且注水泥之前，方井同样接受从井眼内返出的、必须被泵回到地表泥浆设备中的泥浆。

19

The flexing action of the sleeve breaks up any sediment or build-up in the valve , which makes the Type A a reliable low-maintenance valve .

套管的弹性运动可以碎裂淤积在阀门内的任何沉淀物，这使得 A 型夹管阀成为一款可靠的低维护的阀门。

20

A first end cap is located adjacent the first end of the tube , wherein the first end cap comprises at least one air hole .

第一端盖位于套管的第一端附近，其中第一端盖包括至少一个气孔。

21

Check the specification of drill stem, measure its length and that of surface casing .

检查钻具规格，丈量钻具和表层套管长度。

22

A sound impulse emitted by the tool at the surface reflects tubular collar reflectors and the liquid surface .

仪器发射的声波脉冲在套管接箍和液面位置发生发射。

23

The entire procedure may be completed through the cannulas or by lengthening one of the small cannula incisions .

全部手术可以完全利用套管进行或者需要扩大其中一个套管的切口。

24

While I was at it, I overcast the top edge so I don't need to fold under a hem for the casing .

虽然我在这时候，我阴顶部边缘，所以我不需要折为下套管下摆。

25

26

The top of the long rod is fixedly connected with the bearing frame , and the casing is fixedly connected with the transverse walk frame .

长杆的顶端与承重架固定连接，套管与横向行走机架固定连接。

27

and a clearance is formed between the small sleeve and the primary sleeve and is closed by ring slot pouring cement .

其与原套管之间有间隙，并由环隙灌注水泥封闭。

28

An enlarged pipe at the top of a casing string that serves as a funnel to guide drilling tools into the top of a well .

套管柱顶部的一根大口径管，形如漏斗，以引导钻井工具进入到井眼的顶部。

29

The types of heating arrangements normally used for bearings are suitable , e. G. Heating cabinets, oil baths or induction heaters.

对轴承的普通加热方式，如加热柜、油浴或感应炉等，对套管加热也同样适合。

30

and a sleeve connection part arranged between the main body part and the sleeve supporting part for fixing the end part of the sleeve .

套管连接部，其设于上述主体部与上述套管支承部之间，固定上述套管的端部。

热词推荐

大家在看