大家在查： zhuaxia 飞机空战 busta javaandParseException—— reveals a shipping casks 瓦利德•马塔尔阿内尔•罗霍 RCP-LV Wxxg

度公差

度公差

度公差

度公差

1

Numerical results showed that on this assumed condition , the smaller the tolerance of roundness is, the longer the fatigue life of hole.

数值模拟结果表明，在此假定条件下，孔的圆度公差越小，孔的疲劳寿命越大；

2

Flatness tolerance easy to control .

容易控制平面度公差。

3

NON-ROTATING STEM Non-rotating stem has close roundness and straightness tolerances and is burnished for a superior finish .

不旋转阀杆不旋转阀杆具有精密的圆度和平直度公差，并且经过抛光达到极高的抛光度。

4

This paper analyses roundness error by means of minimum zone law, and then a mathematics model is put forward .

在直线度、平面度公差判定的最小包容区域法中提出一个新的、快速的实施方法。

5

Radial run-out tolerance and axiality tolerance that often used in tolerance of form and position are positioning tolerance .

径向跳动公差与同轴度公差是形位公差项目中常用的位置公差。

6

The proposed tolerance system is complementary to the existing geometrical roundness tolerance system.

提出应以统计圆度公差作为几何圆度公差的补充与发展。

7

door leaves - height , width , thickness and squareness - tolerance classes .

门扉。高度宽度厚度和垂直度。公差等级。

8

9

Door leaves - General and local flatness - Tolerance classes.

门扉 .总体和局部平整度 .公差级

10

ty tolerance may be greater than the size tolerance .

因度公差可以大于尺寸公差。

12

Analysis of the Tolerance Range of Linearity of Generatrix of a Cylinder

圆柱面素线的直线度公差带解析

13

A fast evaluation of straightness and flatness tolerance by the mean of classifying measured points

直线度平面度公差的快速评定测点分类法

14

Opinions on the adoption of the independent principle in the marking of the positional tolerances

对位置度公差采用独立原则标注的浅见

15

Doors leaves - Height, width, thickness and squareness - Tolerance classes

门扇高度、宽度、厚度和方度公差级

17

Application of Tolerance Principles Referring to Position Tolerance

不同的公差原则在位置度公差中的应用

19

Statistical Tolerance of Roundness and Assessment

统计圆度公差及其误差评定的研究

20

Study on Tolerance of Degree of position of Axis for Limiting Holes Group

位置度公差在限制孔组轴线中的研究

热词推荐

大家在看

man , . cum you 's " after japan ? : - join Facebook what Yeah play your then 4th